I currently have a Dittel mounted at the bottom of the stack. I would like to replace it with a Becker. Is there an "adaptor" to change the mounting hole from the square Dittel to the round Becker?

I've never seen such a thing, but it might not be too much work to
simply remove the panel, remove all of the switches and instruments, and
plug the square hole with fiberglass or carbon.Â* Then cut a new round
hole and remount the things you removed.Â* Except for the cure time on
the resin, it should be less than a day's work.

Good luck!

Dan
5J

On 6/10/21 9:31 AM, Phoenix wrote:
> I currently have a Dittel mounted at the bottom of the stack. I would like to replace it with a Becker. Is there an "adaptor" to change the mounting hole from the square Dittel to the round Becker?

On Thursday, June 10, 2021 at 2:19:22 PM UTC-4, Dan Marotta wrote:
> I've never seen such a thing, but it might not be too much work to
> simply remove the panel, remove all of the switches and instruments, and
> plug the square hole with fiberglass or carbon. Then cut a new round
> hole and remount the things you removed. Except for the cure time on
> the resin, it should be less than a day's work.
>
> Good luck!
>
> Dan
> 5J
> On 6/10/21 9:31 AM, Phoenix wrote:
> > I currently have a Dittel mounted at the bottom of the stack. I would like to replace it with a Becker. Is there an "adaptor" to change the mounting hole from the square Dittel to the round Becker?
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
This might work:

https://www.segelflug.de/osclass/index.php?
page=item&id=54270

RO

On Thursday, June 10, 2021 at 2:39:12 PM UTC-4, wrote:
> On Thursday, June 10, 2021 at 2:19:22 PM UTC-4, Dan Marotta wrote:
> > I've never seen such a thing, but it might not be too much work to
> > simply remove the panel, remove all of the switches and instruments, and
> > plug the square hole with fiberglass or carbon. Then cut a new round
> > hole and remount the things you removed. Except for the cure time on
> > the resin, it should be less than a day's work.
> >
> > Good luck!
> >
> > Dan
> > 5J
> > On 6/10/21 9:31 AM, Phoenix wrote:
> > > I currently have a Dittel mounted at the bottom of the stack. I would like to replace it with a Becker. Is there an "adaptor" to change the mounting hole from the square Dittel to the round Becker?
> >>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
> This might work:
>
> https://www.segelflug.de/osclass/index.php?
> page=item&id=54270
>
> RO
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
This will convert either an old rectangular radio hole, or
with the bigger plate convert an 80mm / 3.125" hole.
To contact the seller, first go to the main site, use the
English button and register (free) to be able to use the
site.
RO